Support Center

Introductory Training (1)

• Introduction: Printhead installation, Setting The IP Address
• Part 1: Control Panel, Feeder, and Alignment Section
• Part 2: Basic Maintenance (Replacing Inks and the service station)
• Part 3 - Software Guide
• Assembling the High Capacity Auto Loader

• Running The High-Capacity Auto Loader On The iJetColor 1175P

Official Documentation (2)

• Product Technical Bulletins

• 1175P Manual 1.0 - Pi Version (Depreciated)
• 1175P Manual 2.0.1 - Arduino Version (Current)

Print Quality (5)

• The Print Quality Optimizer

• Die Adjustment Tool v1.0 (Depreciated)
• Stair Stepping on HP 1175P
• Various Print Quality Issues and Solutions- from Manual 2.0
• Check Service Sled
• Reflex Blue

Software Downloads (1)

• Print Quality Optimizer Download

Replacing Parts (9)

• Changing the Service Station (Attention needed error)
• Printhead Replacement
• Retrofitting and Replacing the Print Platen
• Swapping to the Pro+ Feeder
• Replacing The Transmission Belt

Replacing Parts (Advanced) (8)

• Replacing the Feeder Belts
• Replacing the Green Belts
• Replacing the Alignment Section
• Replacing the Blue Belt
• Replacing the TOF sensor

The DFE (5)

• Bringing Jobs Into The DFE
• Using The Quick Edits Menu
• The Full Job Editor
• Paper Profiles and Resolution
• Editing Spot Colors using the iJetColor DFE

Troubleshooting (7)

• DFE Warnings and Errors: Common Causes and Solutions - from Manual 2.0
• Calibrating the TOF sensor
• Service Station Motor Stall Troubleshooting
• Feeder Troubleshooting and the COM Port
• Blue Belt Troubleshooting/Motor Alarm Codes